phenix
#0
Hej... jeg har et problem med min com... en gang i mellem får jeg fejlen med blå skærm Kernel_data_Inpage_error. 0x0000007A.
hvad kan der være galt... håber nogle kan hjælpe :/
mvh phenix
hvad kan der være galt... håber nogle kan hjælpe :/
mvh phenix
#1
Stop 0x7A can be caused by bad sectors in the virtual memory paging file, disk controller error, virus infection, or memory hardware problems. In extremely rare cases, depleted nonpaged pool resources can cause this error. If the first and third parameters are zero, the stack signature in the kernel stack is missing, an error typically caused by defective hardware. If the I/O status is 0xC0000185 and the paging file is on a SCSI disk, check for cabling and termination issues. An I/O status code of 0xC000009C or 0xC000016A indicates that the requested data could not be found. You can try to correct this by restarting the computer. If a problem with disk integrity exists, Autochk, a program that attempts to mark bad disk sectors as defective so that they are not used in the future, starts automatically. If Autochk fails to run, you can manually perform the integrity check yourself by following the instructions to run Chkdsk provided in "Stop 0x00000024 or NTFS_FILE_SYSTEM" earlier in this appendix. For more information about Autochk and Chkdsk, see "Troubleshooting Disks and File Systems" in this book.
Dvs.. Måske defekt hdd.. lav en overfladescanning på den med:
start -> kør -> cmd ( enter ) -> chkdsk /r
Mvh
Dvs.. Måske defekt hdd.. lav en overfladescanning på den med:
start -> kør -> cmd ( enter ) -> chkdsk /r
Mvh
#2
#3
tak for hjælpen...
mvh phenix
mvh phenix