dentax
#0
hej hej
Hvordan er det nu lige man får genoprettelsespartition
til at slette det nu værne OS,og genopret OS system
til florbriks indstillinger
computeen er en acer aspire 6920
Tråden blev redigeret 1 gang, sidst af dentax d. 05-05-2012 12:59:54.
Hvordan er det nu lige man får genoprettelsespartition
til at slette det nu værne OS,og genopret OS system
til florbriks indstillinger
computeen er en acer aspire 6920
Tråden blev redigeret 1 gang, sidst af dentax d. 05-05-2012 12:59:54.
#1
Er det ikke Alt + F10 under opstart
#2
D2D skal være slået til i bios
#3
så når jeg har slået D2D i bios til,skal jeg så trykke (Alt f10)det prøver jeg lige 🙂
#4
nu har jeg slået d2d til i bios.Men vis jeg trykke Alt f10 under opstart sker der ikke noget,
#5
har selv fundet løsningen på det.
kan gøre det via EaseUS Partition Master
Men ellers tak for hjælpen 😲
kan gøre det via EaseUS Partition Master
Men ellers tak for hjælpen 😲
#6
mener det er ALT F8 på en acer..
#8
Note: If your system is the multilingual version, the operating
system and language you choose when you first turn on the
system will be the only option for future recovery operations.
This recovery process helps you restore the C: drive with the original software
content that is installed when you purchase your notebook. Follow the steps
below to rebuild your C: drive. (Your C: drive will be reformatted and all data
will be erased.) It is important to back up all data files before using this option.
Before performing a restore operation, please check the BIOS settings.
1 Check to see if Acer disk-to-disk recovery is enabled or not.
2 Make sure the D2D Recovery setting in Main is Enabled.
3 Exit the BIOS utility and save changes. The system will reboot.
Note: To activate the BIOS utility, press <F2> during POST.
To start the recovery process:
1 Restart the system.
2 While the Acer logo is showing, press <Alt> + <F10> at the same time to
enter the recovery process.
3 Refer to the onscreen instructions to perform system recovery.
http://support.acer.com/acerpa... ;s%20manual%2020080219.pdf
system and language you choose when you first turn on the
system will be the only option for future recovery operations.
This recovery process helps you restore the C: drive with the original software
content that is installed when you purchase your notebook. Follow the steps
below to rebuild your C: drive. (Your C: drive will be reformatted and all data
will be erased.) It is important to back up all data files before using this option.
Before performing a restore operation, please check the BIOS settings.
1 Check to see if Acer disk-to-disk recovery is enabled or not.
2 Make sure the D2D Recovery setting in Main is Enabled.
3 Exit the BIOS utility and save changes. The system will reboot.
Note: To activate the BIOS utility, press <F2> during POST.
To start the recovery process:
1 Restart the system.
2 While the Acer logo is showing, press <Alt> + <F10> at the same time to
enter the recovery process.
3 Refer to the onscreen instructions to perform system recovery.
http://support.acer.com/acerpa... ;s%20manual%2020080219.pdf
#9
Nogen gange er det faktisk bare F10 selvom det i manuelen står som ALT+F10 😛
#10
tit skal man tryk et bare gange før det virker..